BERETTA SHOTGUN PARTS-CHOKE TUBE WRENCH

CHOKE TUBE WRENCH

SCHEMATIC REFERENCE – 12 GAUGE
PART NUMBER - JCW12 

SCHEMATIC REFERENCE – 20 GAUGE
PART NUMBER – JCW20

SCHEMATIC REFERENCE – 28 GAUGE
PART NUMBER - C5D301

SCHEMATIC REFERENCE – .410 GAUGE
PART NUMBER - C5E142

UPGRADE TO A 12 Gauge COLE SPEED CHOKE WRENCH CLICK HERE

UPGRADE TO A 20 Gauge COLE SPEED CHOKE WRENCH CLICK HERE

Beretta shotgun part CHOKE TUBE WRENCH for 12 gauge, 20 gauge, 28 gauge, .410 gauge. A choke tube wrench is a tool that helps you to install, remove, or adjust the choke tubes of your shotgun. Choke tubes are devices that fit inside the barrel of a shotgun and affect the spread of the shot pellets. Different choke tubes can be used for different purposes, such as hunting, trap shooting, or skeet shooting. A choke tube wrench allows you to change the choke tubes easily and safely, without damaging the barrel or the tubes. Some choke tube wrenches are universal, meaning they can fit any gauge or brand of shotgun, while others are specific to certain models or sizes. You can find various choke tube wrenches online or in gun stores

Cole Gunsmithing Service Work Order Request Form CLICK HERE

Cleaning your Beretta over and under competition shotgun is important to keep it in good condition and ensure it functions properly.
Here’s a guide on how to clean a Beretta over and under shotgun:
At the end of a hunting or shotting session, clean the shotgun and make sure the chokes are properly tightened. Metal surfaces on shotguns without protective surface treatment need to be cleaned thoroughly and lubricated after every use to protect against rust. Use a cotton cloth soaked in Beretta gun cleaner and a cleaning rod to remove firing residues from the barrels. Use a bronze brush if necessary. Always insert the cleaning rod into the cartridge chamber. Run a clean, dry cloth through the bores to remove detergent residues. Lightly oil the bores with Beretta gun oil on a clean cotton cloth.
Never apply too much oil. A buildup of oil will attract dirt, and this can interfere with the shotgun’s operation and reliability. lean the inner face of the receiver (especially the area around the firing pin holes) and oil lightly. Do not allow oil to enter the firing pin holes. The hinge pin area is a very important coupling area. The receiver and fore-end iron are subject to very high loads and if not properly oiled, could cause seizing of parts or shotgun malfunctioning. Always make sure these parts are lubricated, following the instructions provided. Carefully clean the outer surfaces of the shotgun to remove all traces of dirt, sweat and fingerprints. Apply a thin layer of gun oil (good quality) to the shotgun, using a soft cloth. WARNING… XCESS OIL OR GREASE CAN OBSTRUCT THE BORE, EVEN PARTIALLY; THIS MAKES FIRING VERY DANGEROUS AND CAN DAMAGE THE SHOTGUN AS WELL AS CAUSING SERIOUS INJURY TO THE SHOOTER AND BYSTANDERS.

COLE GUNSMITHING IS THE WORLDS LARGEST BERETTA PREMIUM SHOTGUN DEALER